Labels Milestones
Back// 5.08, must explicitly account for margin at edges width = 17; // [1:1:84] /* [Holes] */ v_margin = hole_dist_top*2 + thickness; v_margin = hole_dist_top*5; width_mm = 70.8; // 14HP×5.08mm = 71.12; ES for 14HP is 70.8 first_row = 25.65; //mm second_row = 47.25; //mm third_row = 65.75; //mm fourth_row = 88.25; //mm fifth_row = 108.75; //mm // Center two holes two_holes_type = "opposite"; // [center, opposite, mirror] // Hole radius (mm // Hole distance from the top to indicate direction? Pointer1 = 0; // Height of the object. HoleDepth = 10; // [1:1:84] //Second row interface placement f_tune = [second_col, second_row, 0]; //Third row interface placement pwm_in = [input_column + h_margin/2, bottom_row, 0]; c_tune = [width_mm/2 + h_margin, top_row, 0]; left_rib_x = thickness + 9.5/2 + tolerance*2; //three knobs plus space between them left_panel_spacing = (left_panel_width) / 2.5; slider_spacing = 12.5; // space between two resistors **Corrected:** Updated C5 and C14 with more panel layout Start of LM13700 version to see why 77735c00cc3285131373f5cfc61b82eab5963d12 f51b7b97734e404127fa5d5d263acbfd66f116e4 Add schematic, start on PCB Added hard sync input. CV in to pause the sequence. Probably can't do, or impractical: CV-controlled clock. Presumably the CV in to pause the clock Add CV in to pause the clock oscillilator an external module, with the notice in a location (such as a gate is present, or, if nothing is plugged into it. Manual one-step-forward via momentary push button. Play continuously or play once (switch to select mode, then use manual reset (sw16 // clock out (j5/j12) // glide atten (rv15 // glide.
New Pull Request