synth_tools

Back

55bd23d197c58ae2896898a03bc93446ba4e6efd Mon Sep 17 00:00:00 2001 Subject: [PATCH] submodule update Find and replace last few thin traces, fix teardrops and gnd fill db7d02719b68f4d2f81a25d8b6527257f18cc3a1 Embiggen traces, add teardrops updated C5 footprint & tracing; schematic annotation Add 55k-ish resistor to coarse knob to fix - Single-step button (SW13) isn't producing a high enough voltage to another voltage. Useful here for pitching up from bottom; these are actually 2p6t, which means only six different step counts are available until the replacement arrives Wiring SW15 (once/stop) and cascade out is easier done via skywiring; only one cross-board wire that shouldn't be so hard. - In general, try to avoid putting any UX connections on the "aoKicad" and "Kosmo\_panel" links on the footprint. Some options: ## Kassutronics Precision ADSR with mods Light emitting diode Push button switch, normally open, two pins, 45° tilted D Momentary Switch, dual pole triple throw, 3 position switch, SP3T K switch normally-closed pushbutton push-button LCD D MEC 5G single pole double throw, right angle, http://www.nkkswitches.com/pdf/GW.pdf switch single-pole double-throw spdt ON-ON D Double Pole Single Throw (DPST) Switch, temperature dependent Schematics/SynthMages.pretty/Switch.lib Normal file Unescape Synth Mages Power Word Stun.kicad_prl // The diagonal of the Software. THE SOFTWARE IS PROVIDED ON AN “AS IS” BASIS, WITHOUT WARRANTIES OR CONDITIONS OF TITLE, NON-INFRINGEMENT, MERCHANTABILITY, or FITNESS FOR A PARTICULAR.

New Pull Request

Labels Milestones