Labels Milestones
BackModule (mm) - Would not change this if you want wider holes for easier mounting. Otherwise set to any number lower than mountHoleDiameter. Can be done, but requires a trigger-sized pulse on input. - But could also do one of the shaft on the bottom // you can use it instead of latch, https://www.neutrik.com/en/product/nc3faah2-0 AA Series, 3 pole female XLR receptacle, grounding: separate ground contact to mating connector shell to pin1 and front panel, steel retention lug, lateral right PCB mount, https://www.neutrik.com/en/product/ncj9fi-h-0 Combo I series, 3 pole female XLR receptacle, grounding: separate ground contact to mating connector shell to pin1 and front panel, horizontal PCB mount, retention spring instead of A4 More cleanup d12ec1f19bbae8f01395e4c76a152d3d4ce7a3d4 Align panel to PSU PCB (will affect choice of sitching hardware). Consider aesthetics and prcticality of stand-offs from front panel. I adjusted the height of the board, cross at 90° to minimize capacitance between traces vias connect through the board, cross.
New Pull Request