Labels Milestones
BackAs low as 2v could works as an edge cut? Corrected in Rev 2.0 alpha 1: Properly assign potentiometer pads and trace routing to de-bodge the pots. 's notes on updating the two clockwise-most pins, looking from below. Clock rate goes down when resistance goes up, opposite to expectation. C1 is too small for film; is film needed? - Smaller cap (476nF?) for C1 Ceramic 104s for C10, C14, might be fine, might introduce intermittents - Don't put R8 so close to R26 - D36/R47 too close - Trim 5mm from vertical for both panels, to make fitting inside.
- 1.163247e-03 3.700590e-01 vertex -1.082406e+02 9.725134e+01 4.877984e+00 vertex -1.081833e+02.
- 3.69322 -4.02975 21.8414 vertex.
- Labels, etc surface("FIREBALL VCO.png", center=true.
- MNR04 (see mnr_g.pdf Chip Resistor Network.
- 9.415535e-001 3.759806e-003 3.368427e-001 facet.