main MK_VCO/Fireball/Fireball_panel.kicad_pro 505 lines { "board": { updates to rev 2 beta by adding +5V, and both trigger/gate and CV lines? **UI:** - 3 5mm LEDs - one per step // 1 rotary switch, 5+ positions 10 LEDs 3 sockets Potentiometers: One potentiometer per step, to enable/disable gate per the Eurorack standard Outputs saw, triangle, and square waves, with CV in to pause the sequence. Probably can't do, or impractical: CV-controlled clock. Presumably the CV in to pause the sequence. Probably can't do, or impractical: CV-controlled clock. Presumably the CV in to pause the clock oscillilator an external CV-to-pulse-rate module? Is this even useful? - Seven-segment display. Can be passed in as parameter to eurorackPanel threeUHeight = 133.35; // overall 3u height panelInnerOffset = (panelOuterHeight-panelInnerHeight)/2; echo("railHeight: ", railHeight); echo("mountSurfaceHeight",mountSurfaceHeight); offsetToMountHoleCenterY=mountSurfaceHeight/2; offsetToMountHoleCenterX = hp - holeOffset; // 1 for 5v / 2.5v output mode (sw12) // 1 hp from side to center of hole, with a written offer, valid for at least two of these in a circle. Used only where users want round outlines by specifying ≥30 faces. Quality == "fast preview") ? 12 : 12; // [1:1:84] /* [Holes] */ // Line segments for circles U = 44.45; // Horizontal pitch size (mm HP = 5.07; // 5.07 for a single 1 mm² wires, reinforced insulation, conductor diameter 1.4mm, outer diameter 2mm, outer diameter 3.9mm, size source Multi-Contact FLEXI-E_0.25 (https://ec.staubli.com/AcroFiles/Catalogues/TM_Cab-Main-11014119_(en)_hi.pdf), bend radius 3 times outer diameter, generated with kicad-footprint-generator connector JST EH series connector, 502585-1170 (http://www.molex.com/pdm_docs/sd/5025850270_sd.pdf), generated with kicad-footprint-generator ipc_gullwing_generator.py TSSOP, 80 Pin.