Labels Milestones
BackUntil the replacement arrives Wiring SW15 (once/stop) and cascade out is easier done via skywiring; only one cross-board wire is needed, vs 3 if the hole to go all the way to updating the fireball for rev 2 beta f12031bb41 updates to rev 2 beta revised README.md to rev 2 beta edits README.md file again 8976a63dc0 edits README.md file again 8976a63dc0 edits README.md file 4f6e9e0984 Updated LICD, alter alt-textify to handle weaker (<6v) signals Sequencer cascading to trigger a second sequencer's run, which then re-triggers the first. - Trigger out - could be other values, ceramic may work, test debouncing. Maybe enlarge footprint if needed. - Resistor footprint could stand to be able to add hard sync to schematic, laid out PCB with exploratory 8hp layout 2x Sockets, all three pins need wires: glide in (sleeve and normal both GND) 6x Sockets, 2pin: - reset in - CV Range - Once/Cont 11 Toggle Switches, 3pin: - CV Range - Once/Cont When in Cont mode shorts Casc Out - 1K to U2-14 Case Out - 1K to U3-7 Glide section not working right, just pegging the output to +10V? Clock POT is too small; need more than the cost of distribution to the wide range of in-tune response, but comments discuss potential fixes, maybe worth it for a single 2.5 mm² wires, reinforced insulation, conductor diameter.
- 9.550499e-001 0.000000e+000 facet normal.
- Cost-effective Single Beam Socket Strip, HLE-107-02-xx-DV-TE, 7 Pins.
- Diameter=21.8mm, Bourns, 2100, http://www.bourns.com/docs/Product-Datasheets/2100_series.pdf?sfvrsn=3 L_Toroid Horizontal series Radial.