Labels Milestones
Back// additives - labels, etc // one more to mount the circuit board to, dead center // one more to mount a circuit board to, dead center // pcb_holder(h=10, l=top_row-rail_clearance*2-15-thickness, th=1.15, wall_thickness=1); // lower h-rib reinforcer cylinder(r=hole_r, h=thickness*2); echo("Putting a hole with radius: ", hole_r , " at ", hole_dist_side, height - v_margin*2 - title_font_size; working_increment = working_height / 5; row_2 = working_increment*1 + row_1; //special-case the top surface, or not. Enable_engraved_indicator = false; // Height of the remainder of the round part of the rail + a safety margin // margins from edges v_margin = hole_dist_top*2 + thickness; right_rib_x = width_mm - h_margin; out_row_1 = v_margin+12; row_2 = row_1 + v_margin + 12; title_font = 10; // [1:1:84] fm_in = [h_margin+working_width/8, row_3, 0]; cv_in_2b = [right_col, row_5, 0]; audio_out_1 = [right_col, row_5, 0]; audio_out_1 = [right_col, row_3, 0]; c_tune = [width_mm/2 + h_margin, top_row, 0]; f_tune = [second_col, fourth_row, 0]; //Fifth row interface placement pwm_in = [input_column + h_margin/2, bottom_row, 0]; cv_in = [first_col, first_row, 0]; c_tune = [width_mm/2, top_row, 0]; left_rib_x = thickness + 9.5/2 + tolerance*2; //three knobs plus space between them right_panel_width = width_mm - col_right + tolerance*4; //three knobs plus space between them right_panel_width = width_mm - thickness; left_panel_width = 16.5+16.5+10.5; //two knob, one jack, plus space between them right_panel_width = width_mm - 10 - center_adjust; center_col = width_mm/2; row_1 = v_margin+12; out_row_2 = out_working_increment*1 + out_row_1; out_row_4 = out_working_increment*3 + out_row_1; out_row_5 = out_working_increment*4 + out_row_1; out_row_7 = working_increment*6.
New Pull Request