synth_tools

Back

Avoid non-circular holes in footprints whenever possible; some fabs charge more for ovals PCB layout: [front](Docs/precadsr_layout_front.pdf), [back](Docs/precadsr_layout_back.pdf) * [BOM](Docs/precadsr_bom.md) * [Build notes](Docs/build.md) How to use your choice of 9 mm vertical board mount | | | | | J2 | 1 | AudioJack2_SwitchT | Audio Jack, 2 Poles (Mono / TS), Switched T Pole (Normalling Audio Jack, 2 Poles (Mono / TS) | | Tayda | A-2939 | | | | C1 | 1 | 1 | AudioJack2_SwitchT | Audio Jack, 2 Poles (Mono / TS), Switched T Pole (Normalling)"/> Add note that C12 is optional; not needed if using real TL0x4, fix pots being backwards, tighten up schematic, fit letter instead of latch, https://www.neutrik.com/en/product/nc3fahr2-0 A Series, 3 pole female XLR receptacle, grounding: separate ground contact to mating connector shell to pin1 and front panel, vertical PCB mount, https://www.neutrik.com/en/product/ncj6fa-h Combo A series, 3 pole XLR female receptacle with 6.35mm (1/4in) stereo jack, switched, with full threaded nose and offset PCB pins, https://www.neutrik.com/en/product/nmj4hcd2 M Series, 6.35mm (1/4in) mono jack, switched, with full threaded nose and offset PCB pins, https://www.neutrik.com/en/product/nmj4hfd2 M Series, 6.35mm (1/4in) stereo jack without switching contact, vertical PCB mount, https://www.neutrik.com/en/product/ncj6fa-h Combo A series, 3 pole female XLR receptacle, grounding: separate ground contact to mating connector shell to pin1 and front panel.

New Pull Request

Labels Milestones