Labels Milestones
BackMaybe activate? Clock Out - 1K to TP5 Gate Out - Diode from rotary pin 13 - CV Range - Once/Cont 11 Toggle Switches, 2pin: - step - reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below - Glide, manual (A100k) (two left pins, from below) - Clock In - diode to U2-3 Clock In Normal - 1k to U2-8 (AND NOT short to U2-10 Clock Rate - variable resist +6k between U2-8 and U2-9 - Reset Socket to U3-3 = capacitor measurement roughly 15nF (has a resistor as well - Once/Cont 11 Toggle Switches, 2pin: - Glide attenuator (B10k) (join two left pins from below Pots, 2-pin: - Glide, manual (A100k) (two left pins, from below - Glide, manual (A100k) (two left pins, from below) Pots, 2-pin: - Glide, manual (A100k) (two left pins, from below) - Clock rate goes down when resistance goes up, opposite to expectation. C1 is too small for film; is film needed? - Smaller cap (476nF?) for C1 - Ceramic 104s for C10, C14, might be more robust and easier to adjust CV output range, switch between 5v and 2.5v max (or whatever is configured). - Momentary-normal-off pushbutton to manually reset. - One potentiometer per step, to set clock rate (if onboard clock is used) (rv11 // 1 for 5v / 2.5v output mode (sw12 // 1 hp from side to a D-shaped hole, set this to zero. ScrewHoleDiameter = 3; // Number of faces around the knob? Knurled = 1; // [0:No, 1:Yes] // 0 if indicator faces notch, 180 if it faces away and so on. // body - hole // handle + rest.
New Pull Request