Labels Milestones
BackVertical_space/7; row_7 = row_6 + vertical_space/7; row_7 = row_6 + vertical_space/7; row_4 = row_3 + vertical_space/7; row_6 = row_5 + vertical_space/7; cv_in_1a = [left_col, row_1, 0]; pwm_in = [width_mm - h_margin - working_width/8, row_3, 0]; pwm_duty = [input_column, row_2, 0]; fm_in = [input_column - h_margin/2, row_1, 0]; fm_pot = [input_column - h_margin/2, row_1, 0]; square_out = [width_mm-h_margin, row_1, 0]; fm_pot = [input_column + h_margin/2, bottom_row, 0]; c_tune = [width_mm/2 + h_margin, top_row, 0]; left_rib_x = thickness + 9.5/2 + tolerance*2; // rib + half a jack col_right = width_mm - h_margin; input_column = h_margin; col_right = width_mm - h_margin; input_column = h_margin; col_right = width_mm - thickness*2; // How much horizontal space needed for left-hand and right-hand sub-panels left_panel_width = 12.5*3 + tolerance*4; //three knobs plus space between them //left_panel_spacing = left_panel_width / 3 + tolerance*8; right_panel_width = width_mm - thickness*2; // How much horizontal space needed for left-hand and right-hand sub-panels right_panel_width = 12; // overkill; currently three 3.5mm jacks needing 8mm //calculated x value of exact middle of slider panel (between steps 5 and 6 // manual reset (sw16 // clock out (j5/j12) // glide in (sleeve and normal both GND 6x Sockets, 2pin: Gate out (could.
New Pull Request