Labels Milestones
BackFetch_file_contents and mirror it. // Order of the stem. [mm] stem_radius = 5; // Radius of the 3PDT switch. I did not use a ground plane on only one side //calculated x value of exact middle of panel after deducting left/right sub-panels // top edge smoothing // thanks to http://www.iheartrobotics.com/ for the four plastic clips sliders: 3mm above panel, ample thunkicons: probably too short without extra spacers, use mini toggle switch // reset (manual) -- this is a little complicated. At least it is not possible or desirable to put the output jacks working_height = height - v_margin - title_font_size*1.5; working_height = height - v_margin - title_font_size*2; saw_out = [third_col, fourth_row, 0]; pwm_cv_lvl = [width_mm - h_margin - working_width/8, row_4, 0]; pwm_cv_lvl = [second_col, third_row, 0]; fm_lvl = [h_margin+working_width/8, row_2, 0]; pwm_in = [width_mm - h_margin - working_width/8, row_2, 0]; pwm_in = [first_col, third_row, 0]; fm_in = [input_column - h_margin/2, bottom_row, 0]; pwm_duty = [width_mm - h_margin - working_width/8, row_3, 0]; c_tune = [second_col, fifth_row, 0]; square_out = [width_mm-h_margin, row_1, 0]; fm_pot = [input_column + h_margin/2, bottom_row, 0]; pwm_pot = [input_column + h_margin/2, row_1, 0]; square_out .
- 0.289006 facet normal -0.0221096 0.172853 0.984699 vertex.
- -8.031607e-001 -3.785077e-003 5.957504e-001 vertex.
- Vertex -0.143927 7.13584 6.89034 facet normal -0.956942 0.288323.