Amplifier, DIP-8"/> Standard switching diode, DO-35 | | J7, J8, J9 | 1 | Synth_power_2x5 | 2x5 pin shrouded header 2.54 mm spacing | Tayda | A-004 | | | J3 | 1 uF | Unpolarized capacitor | Tayda | A-4755 | | R15, R17, R19 | 2 Hardware/Panel/precadsr-panel/sym-lib-table | 2 | 1N5817 | Schottky diode | | | 1 | 1 | SW_Push | Push button switch, normally open, two pins, 45° tilted D Momentary Switch, dual pole double throw | | | | | U3 | 1 | 2_pin_Molex_connector | 2 pin Molex header 2.54 mm spacing | | Tayda | A-1847 | | 8 pin connector, https://www.te.com/commerce/DocumentDelivery/DDEController?Action=showdoc&DocId=Customer+Drawing%7F215079%7FY1%7Fpdf%7FEnglish%7FENG_CD_215079_Y1.pdf%7F215079-4 connector TE-Connectivity Micro-MaTch female-on-board top-entry thru-hole 14 pin DIP socket A-004 4 Knobs Screws, nuts, and spacers (see [build notes](build.md | | | | | | | | D6, D7 | 2 pin Molex connector 2.54 mm spacing Pin header 2.54 mm spacing | | | | | | | Tayda | A-1605 | \* Fit SIP socket for\nsocketing capacitors C13 marked 1 nF\non first run PCB Precision ADSR with modifications This won't be easy; need both A1M (x3) and B10K (x1) sliders in the LED footprint and socketed the LED. If I ever do a new fetcher, use the two clockwise-most pins, looking from below. Clock rate (B100k) (not sure yet which 2 pins diameter 5.0mm 2 pins clear LED, Round, FlatTop, diameter 5.0mm, 4 pins, pitch 10mm, size 25.8x8.2mm^2, drill diamater 1.1mm, pad diameter 2.5mm, see http://cdn-reichelt.de/documents/datenblatt/C151/RND_205-00078_DB_EN.pdf, script-generated using https://github.com/pointhi/kicad-footprint-generator/scripts/TerminalBlock_MetzConnect THT terminal block Metz Connect Type703_RT10N02HGLU, 2 pins, pitch 5mm, size 15x8mm^2, drill diamater 1.3mm, pad diameter 2.5mm, see http://cdn-reichelt.de/documents/datenblatt/C151/RND_205-00023_DB_EN.pdf, script-generated using https://github.com/pointhi/kicad-footprint-generator/scripts/TerminalBlock_Phoenix THT Terminal Block WAGO 236-601, 45Degree (cable under.
alt
click/enter