12:33:34 AM EDT Sat 28 Aug 2021 07:18:14 PM EDT Generated from schematic into main Merge pull request 'Fix rail clearance = ~11.675mm, top and bottom railHeight = (threeUHeight-panelOuterHeight)/2; mountSurfaceHeight = (panelOuterHeight-panelInnerHeight-railHeight*2)/2; panelInnerOffset = (panelOuterHeight-panelInnerHeight)/2; echo("railHeight: ", railHeight); offsetToMountHoleCenterX = hp - holeOffset; // 1 for run/stop (sw14 // 1 hp from side to center of package, Thorlabs photodiodes, https://www.thorlabs.de/drawings/374b6862eb3b5a04-9360B5F6-5056-2306-D912111C06C3F830/FDGA05-SpecSheet.pdf TO-92 leads molded, narrow, drill 0.75mm, hand-soldering variant with enlarged pads (see NXP SSOP-TSSOP-VSO-REFLOW.pdf and sot556-1_po.pdf 24-Lead Plastic QFN (3mm x 3mm); Pitch 0.4mm; EP 1.7x1.54mm; for InvenSense motion sensors; Mask removed below exposed pad; keepout area marked (Package see: https://store.invensense.com/datasheets/invensense/MPU9250REV1.0.pdf; See also https://www.invensense.com/wp-content/uploads/2015/02/InvenSense-MEMS-Handling.pdf 24-Lead Plastic QFN (4mm x 4mm); Pitch 0.5mm; EP 2.7x2.6mm; for InvenSense motion sensors; Mask removed below exposed pad; keepout area marked (Package see: https://store.invensense.com/datasheets/invensense/MPU-6050_DataSheet_V3%204.pdf; See also https://www.invensense.com/wp-content/uploads/2015/02/InvenSense-MEMS-Handling.pdf 24-Lead Plastic QFN (2mm x 2mm) (see Linear Technology DFN_8_05-08-1698.pdf DFN, 8 Pin (http://www.ti.com/lit/ds/symlink/iso1050.pdf), generated with kicad-footprint-generator Soldered wire connection with feed through strain relief, for 4 times 0.25 mm².