Labels Milestones
Back(HP cv_in = [h_margin, row_1, 0]; fm_pot = [input_column + h_margin/2, bottom_row, 0]; c_tune = [width_mm/2 + h_margin, top_row, 0]; f_tune = [width_mm/2 + h_margin, top_row, 0]; f_tune = [second_col, third_row, 0]; //Fourth row interface placement saw_out = [third_col, fifth_row, 0]; //right_rib_x = width_mm - thickness*2; left_rib_x = thickness + 6 + tolerance; rail_depth = 27.4 + tolerance; rotate_vector_cos = 0.94; // 'x' of 20 degree rotation rotate_vector_sin = 0.34; // 'y' of rotation left_edge = -rotate_vector_sin * rail_depth; right_edge = height / 2 + 3 + tolerance*8; echo("Left panel:", left_panel_width, " with spacing ", left_panel_spacing); right_panel_width = width_mm - hole_dist_side, hole_dist_top); echo("Putting a hole with radius: ", hole_r , " at ", hole_dist_side, hole_dist_top); cylinder(r=hole_r, h=thickness*2); echo("Putting a hole with radius: ", hole_r , " at ", hole_dist_side, height - v_margin*2 - title_font_size; working_increment = working_height / 6; // generally-useful spacing amount for vertical columns of stuff working_height = height - v_margin - title_font; saw_out = [output_column, row_2, 0]; pwm_in = [width_mm - h_margin - working_width/8, row_3, 0]; manual_2 = [left_col, row_7, 0]; cv_in_1b = [right_col, row_2, 0]; fm_lvl = [second_col, first_row, 0]; sync_in = [first_col, fifth_row, 0]; //left_rib_x = thickness * 1.2; right_rib_x = width_mm - 10 - center_adjust; // build up seven rows; middle one unused row_1 = v_margin+12; Experimenting with more panel layout ideas Initial stab at.
- 20-Pin Thermally Enhanced Thin Shrink Small Outline (ST)-4.4.
- 5 pole male XLR receptacle, grounding.