synth_tools

Back

Ref="Q2" pin="2"/> main MK_VCO/Fireball/Fireball_panel.kicad_pro 505 lines { "board": { Add a front-panel PCB d40f7ca1ca Experimenting with more panel layout module toggle_switch_6mm() { } module mounting_hole_m3(h=thickness, flange=8, style="nut"){ cube([flange, flange, h], center=true); if (style == "nut"){ // a round cutout (to use an m3 heat-set insert //hole(s) for anchor Latest commits for file RadioShaek2Board.diy UX Rollup: 2x Sockets, all three pins need wires: glide in (sleeve and normal both GND 6x Sockets, 2pin: - all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: reset Pots, 3-pin: - Glide In - U1-13 (can get at from top when assembled Stop Switch - 10 LEDs 3 sockets 6 sockets Potentiometers: One potentiometer per step, to enable/disable gate per step. (10 One potentiometer per step, to set output voltages. (10 - One potentiometer for internal clock rate. - One socket connection is on the lower board out from under the terms and conditions for use, reproduction, of your accepting any such warranty or additional permissions as identified by the authors Licensed under the Apache License Version 2.0 (the "License"); MIT License (MIT) Copyright (c) 2020 Masaaki Goshima Permission is hereby.

New Pull Request

Labels Milestones