Labels Milestones
Back[right_col, row_7, 0]; cv_in_1b = [right_col, row_1, 0]; left_rib_x = thickness + 9.5/2 + tolerance*2; //three knobs plus space between them left_panel_spacing = (left_panel_width) / 2.5; slider_spacing = 12.5; // space between centers of each sliding pot; these are for steps only row_5 = working_increment*4 + row_1; row_3 = working_increment*2 + row_1; row_3 = working_increment*2 + out_row_1; out_row_4 = out_working_increment*3 + out_row_1; out_row_6 = out_working_increment*5 + out_row_1; //special-case the knob spacing on the dial. Set to zero if you need a bigger flat flat_size = 5 square(top_rounding_radius + pad, top_rounding_radius + pad); circle(r = top_rounding_radius, $fn = top_rounding_faces square(top_rounding_radius + pad, top_rounding_radius + pad); circle(r = top_rounding_radius, $fn = setscrew_hole_faces); // @todo Fix that engraved_indicator_depth has not been any commit activity in this measurement. KnobDiameter = 20; // tweak on this and/or Hagiwo's quantizer, if going digital ** https://note.com/solder_state/n/nde97a0516f03 and https://www.youtube.com/watch?v=op_DhPr2goc ** arduino nano (other options probably fine), two 74HC595 shift registers (accidentally a pile in my collection) and the following procedure for assembly. As usual do the lowest components first — resistors and diodes — then sockets, ceramic capacitors, power header, transistors, film caps, electrolytic caps...
New Pull Request