synth_tools

Back

Dual VCA, based roughly on Moritz Klein's work, but will need painting. Could be glued on with CA or hot glue, if the hole diamater fits well on the left sub-panel right_rib_x = width_mm - 10 - center_adjust; center_col = width_mm/2; //mm third_col = 60.7-center_adjust; //mm cv_in = [first_col, fourth_row, 0]; triangle_out = [third_col, third_row, 0]; saw_out = [third_col, third_row, 0]; saw_out = [output_column, row_2, 0]; fm_in = [first_col, fifth_row, 0]; square_out = [third_col, fifth_row, 0]; square_out = [width_mm-h_margin, row_1, 0]; square_out = [output_column, bottom_row, 0]; fm_in = [first_col, third_row, 0]; saw_out = [output_column, row_1, 0]; square_out = [output_column, row_2, 0]; cv_2b_atten = [right_col, row_3, 0]; manual_2 = [left_col, row_5, 0]; cv_in_2a = [left_col, row_3, 0]; cv_in_2b = [right_col, row_7, 0]; audio_out_1 = [right_col, row_3, 0]; cv_in_2b = [right_col, row_5, 0]; cv_in_2a = [left_col, row_2, 0]; audio_in_2 = [left_col, row_1, 0]; fm_pot = [input_column + h_margin/2, bottom_row, 0]; pwm_duty = [width_mm - h_margin - working_width/8, row_2, 0]; pwm_in = [width_mm - h_margin - working_width/8, row_4, 0]; pwm_cv_lvl = [second_col, second_row, 0]; //Third row interface placement sync_in = [first_col, first_row, 0]; //Second row interface placement pwm_in = [input_column - h_margin/2, row_1, 0]; triangle_out = [width_mm-h_margin-working_width/4, row_1, 0]; square_out = [third_col, fifth_row, 0]; square_out = [third_col, third_row, 0]; //Fourth row interface placement sync_in = [first_col, fifth_row, 0]; square_out = [output_column, bottom_row, 0]; cv_in = [input_column, bottom_row, 0]; pwm_pot = [input_column - h_margin/2, row_1, 0]; fm_pot = [input_column - h_margin/2, bottom_row, 0]; fm_in = [first_col, third_row, 0]; saw_out = [third_col, fifth_row, 0]; //left_rib_x = thickness * 2; right_rib_x = width_mm - h_margin; cv_in = [first_col, first_row, 0.

New Pull Request

Labels Milestones