synth_tools

Back

Use center alignment. Control Labels 2.2mm "Futura Hv BT" (available here). Control label font so we don't lose it Add the line: * in your OpenSCAD script and call either... * knurled_cyl( Knurled cylinder height, * Knurl polyhedron depth, * Cylinder ends smoothed height, * Knurled surface smoothing amount ); * If you don't want markings. (RingWidth must be non-zero.) NotchedShaft = 0; right_rib_x = width_mm - thickness*2; slider_center = (width_mm - left_panel_width - right_panel_width)/2 + left_panel_width; slider_bottom = v_margin+8; module label(string, size=4, halign="center") { // not a comic, just a borked RSS feed elseif (strpos($article['link'], 'gunnerkrigg.com/?p') !== FALSE) { elseif (strpos($article['content'], 'www.asofterworld.com/index.php?id') !== FALSE ) { // The Trenches elseif (strpos($article["link"], "explosm.net/comics") !== FALSE) { $img = preg_replace("@height=\"\d+\"@", "", $img); $img = preg_replace("@width=\"\d+\"@", "", $img); $img = $matches[1]; // Least I Could Do You'll note several of these should be the same, see datasheet: https://www.mouser.com/datasheet/2/54/PTL-777483.pdf (page 4) if we want them to match. We could also do all-different colors, but unfortunately Mouser only has A1Ms in orange. *** Expensive, about $3 each. * Replacing LEDs in many places might be fine, might introduce intermittents - Don't put R8 so close to R26 D36/R47 too close Testing before powering up: Clock In Normal - 1k to U2-8 (AND NOT short to U2-10 Clock Rate - variable resist +6k between U2-8 and U2-9 - Reset Sw - when pressed, short +12V and Reset In socket - Reset Sw - when pressed, short +12V and Reset In - diode to U2-3 Glide In - Pause CV In Latest commits for file README.md Latest commits for file Panels/FireballSpellVertSmaller.png (min_thickness 0.25) (filled_areas_thickness no min_thickness.

New Pull Request

Labels Milestones