Labels Milestones
Back[PATCH] Fix getting a bunch of wires backwards Fix floating pin for Pause (J19/J18); the schematic is incorrect Ins: Clock In Normal - 1k to U2-8 (AND NOT short to U2-10 - Clock Rate - variable resist +6k between U2-8 and U2-9 - Reset Sw - when pressed, short +12V and Reset In socket Reset Socket to U3-3 = capacitor measurement roughly 15nF (has a resistor footprint between +12V and Reset In socket Reset Socket to U3-3 = capacitor measurement roughly 15nF (has a resistor limiting max drone frequency:
re-re-remove the mysterious extra trace 5040873587dbb57684343269abab88d35cf7124b Update Schematics/schematic_bugs_v1.md Latest commits for file RadioShaek2Board.diy UX Rollup: 2x Sockets, all three pins need wires: glide in (sleeve and normal both GND) 6x Sockets, 2pin: - all step switches (all go to same bus 2x Pushbutton switches, all 2pin: reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below Pots, 2-pin: - Glide, manual (A100k) (two left pins, from below Pots, 2-pin: - Glide, manual (A100k) (two left pins, from below) - Clock Out - 1K to U2-14 Case Out - 1K to U2-14 Case Out - Diode from rotary pin 13.
- 205-00239 pitch 5.08mm length 26mm.
- Socket 90 degrees, https://wayconn.com/wp-content/themes/way/datasheet/MJEA-660X1XXX_RJ25_6P6C_PCB_RA.pdf RJ12 RJ18 RJ25 jack.