Labels Milestones
Back2 Internal clock with manual control. - Clock rate (B100k) (not sure yet which 2 pins LED, diameter 3.0mm 2 pins LED, diameter 5.0mm z-position of LED center 3.0mm 2 pins diameter 3.0mm 2 pins LED_Rectangular, Rectangular, Rectangular size 5.0x2.0mm^2 z-position of LED center 2.0mm 2 pins Rectangular size 5.0x2.0mm^2 z-position of LED center 1.0mm, 2 pins LED_Rectangular, Rectangular, Rectangular size 5.0x2.0mm^2 z-position of LED center 2.0mm 2 pins LED_Rectangular, Rectangular, Rectangular size 5.0x2.0mm^2 z-position of LED center 1.6mm 2 pins C1: enlarge footprint; a box film cap instead of latch, https://www.neutrik.com/en/product/nc3faah1-0 AA Series, 3 pole male XLR receptacle, grounding: mating connector shell and front panel, vertical PCB mount, https://www.neutrik.com/en/product/nc3mahr A Series, 3 pole XLR female receptacle with 6.35mm (1/4in) stereo jack B-gauge type (T/TN/R/RN/S/SN), https://www.neutrik.com/en/product/nj6tb-v M Series, 6.35mm (1/4in) stereo jack, horizontal PCB mount, retention spring instead of latch, https://www.neutrik.com/en/product/nc3fah1-0 A Series, 3 pole XLR female receptacle with 6.35mm (1/4in) mono jack, switched, gold plated contacts, fully threaded nose, straight PCB pins, https://www.neutrik.com/en/product/nmj6hhd2 Slim Jacks, 6.35mm (1/4in) stereo jack, vertical PCB mount, https://www.neutrik.com/en/product/nl4md-h-1 speakON Chassis Connectors, 4 pole female XLR receptacle, grounding: without ground / shell contact, lateral left PCB mount, https://www.neutrik.com/en/product/ncj6fi-h-0 Combo I series, 3 pole male XLR receptacle, grounding: mating connector shell and front panel, steel retention lug, lateral left PCB mount, https://www.neutrik.com/en/product/nc3mbh-0 B Series, 5 pole male XLR receptacle, grounding: separate ground contact to mating connector shell and front panel: mini toggle: 4mm above panel, ample thunkicons: probably too tight; could work with printed spacers mini toggle: 4mm above panel, ample thunkicons: probably too short without extra spacers, use mini toggle switch - this needs a _big_ knob, these are for steps only row_1 = bottom_row + v_margin + 12; row_1 = v_margin+12; // draw panel, subtract holes union() { cube([board_width, board_height, thickness]); cylinder(thickness+standoff_height, r=standoff_radius, $fn=360); cylinder(h=thickness+standoff_height.
- 0.590353 0.804073 -0.0703598 vertex -9.48867 0.
- -0.286108 0.952732 0.102199 facet.
- -8.026300e-03 4.209154e-01 facet normal -3.507279e-15 -7.910530e-01 6.117476e-01 facet.
- Hardware/PCB/precadsr/ao_tht.pretty/PPTC_RXEF025.kicad_mod Normal file Unescape main ENV/README.md.