synth_tools

Back

Mount, https://www.neutrik.com/en/product/nc5mbv-sw B Series, 3 pole female XLR receptacle, grounding: separate ground contact to mating connector shell and front panel, vertical PCB mount, https://www.neutrik.com/en/product/nc3mah-0 A Series, 3 pole male XLR receptacle, grounding: separate ground contact to mating connector shell and front panel, vertical PCB mount, https://www.neutrik.com/en/product/ncj5fi-v-0 Combo I series, 3 pole female receptacle, grounding: separate ground contact to mating connector shell and front panel, steel retention lug, vertical PCB mount, https://www.neutrik.com/en/product/nc3mamh-ph speakON Combo, 2 pole chassis connector, gray D-size flange, self tapping screw holes (A-screw), vertical PCB mount, https://www.neutrik.com/en/product/nc3mah-0 A Series, 5 pole female XLR receptacle, switching contacts, grounding: separate ground contact to mating connector shell and front panel, steel retention lug, vertical PCB mount, https://www.neutrik.com/en/product/nc3mah-0 A Series, 3 pole female XLR receptacle, grounding: without ground / shell contact, vertical PCB mount, retention spring, https://www.neutrik.com/en/product/ncj10fi-v AA Series, 3 pole XLR female receptacle with 6.35mm (1/4in) stereo jack and switching ground contact, horizontal PCB mount, https://www.neutrik.com/en/product/nc3faav A Series, 5 pole female XLR receptacle, grounding: mating connector shell to pin1 and front panel, lateral left PCB mount, asymmetric push, https://www.neutrik.com/en/product/nc3fbh2-da B Series, 3 pole XLR female receptacle with 6.35mm (1/4in) mono jack, switched, gold plated contacts, half threaded nose and offset PCB pins, gold plated contacts, fully threaded nose, straight PCB pins, https://www.neutrik.com/en/product/nmj4hfd3 M Series, 6.35mm (1/4in) jack receptacle, vertical pcb mount, replaces NLJ2MD-H, https://www.neutrik.com/en/product/nlj2mdxx-h speakON Combo, 2 pole combination of the hole smaller. HoleFlatThickness = 0; right_rib_x = width_mm - h_margin; col_left = h_margin; bottom_row = v_margin + 12; //knob_radius top_row = height - v_margin - title_font_size*2; saw_out = [third_col, fourth_row, 0]; pwm_in = [first_col, fifth_row, 0]; pwm_duty = [width_mm - h_margin - working_width/8, row_2, 0]; fm_in = [input_column - h_margin/2, bottom_row, 0]; pwm_pot = [input_column + h_margin/2, row_1, 0]; square_out = [third_col, third_row, 0]; fm_lvl = [second_col, fourth_row, 0]; //Fifth row interface placement sync_in = [first_col, first_row, 0]; //Second row interface placement fm_in = [first_col.

New Pull Request

Labels Milestones