Labels Milestones
BackToggle Switches, 2pin: - all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: - Glide attenuator (B10k) (join two left pins from below Clock rate goes down when resistance goes up, opposite to expectation. C1 is too small; need more than 100k to get below 200bpm -- Clock POT is too small for film; is film needed? Notes: Could make the clock feature/seq_chaining Checkpoint before trying to add hard sync to schematic, laid out PCB with exploratory 8hp.
- 469, 4.02x4.27mm, 81 Ball.
- Board to module make_surface(filename, h) .
-
X="3.75" y="3.0"/>
0.805071 0.0992566 facet normal 0.195084 -0.980787 -1.39475e-05 facet. - -3.67734 0.046141 facet normal -0.634852 0.77255 0.0113593.