Labels Milestones
Back//three knobs plus space between them left_panel_spacing = (left_panel_width) / 2.5; slider_spacing = 12.5; // space between them right_panel_width = 12; // overkill; currently three 3.5mm jacks needing 8mm //calculated x value of exact middle of slider panel (between steps 5 and 6 // manual reset (sw16 // clock out (j5/j12 // glide in (sleeve and normal both GND Glide attenuator (B10k) (join two left pins from below Pots, 2-pin: - Glide, manual (A100k) (two left pins, from below - Clock POT is too small; need more than 100k to get 1:1 between schematic and PCB, no warnings d62e7c6861 More work finding space for everything, lining things up more Make slider and LED footprints match current OpenSCAD model Checkpoint after fixes but before shrinking boards 007cc05932dfa23f85127799f5505afc7b25772e New Pull Request