synth_tools

Back

R4, R6, R7, R30, R31 | 5 | 22k | Resistor | | Tayda | A-3588 | \** Use only four (4) potentiometers, either 9 mm vertical pots. You can use it instead of latch, https://www.neutrik.com/en/product/nc3fahr2-0 A Series, 3 pole XLR female receptacle with 6.35mm (1/4in) mono jack, switched, with full threaded nose and straight PCB pins, https://www.neutrik.com/en/product/nmj6hfd4 M Series, 6.35mm (1/4in) stereo jack, switched, with chrome ferrule and straight PCB pins, https://www.neutrik.com/en/product/nmj6hcd3 M Series, 6.35mm (1/4in) stereo jack, horizontal PCB mount, retention spring instead of latch, https://www.neutrik.com/en/product/nc3fahl-0 A Series, 3 pole male XLR receptacle, grounding: ground contact to mating connector shell and front panel, vertical PCB mount, https://www.neutrik.com/en/product/nc3fahl1 A Series, 4 pole male XLR receptacle, grounding: separate ground contact to mating connector shell and front panel, horizontal PCB mount, https://www.neutrik.com/en/product/ncj9fi-v-0 Combo I series, 3 pole male XLR receptacle, grounding: without ground/shell contact, horizontal PCB mount, retention spring, https://www.neutrik.com/en/product/ncj6fi-v Combo I series, 3 pole XLR female receptacle with 6.35mm (1/4in) switching stereo jack, switched, with full threaded nose and offset PCB pins, https://www.neutrik.com/en/product/nmj6hfd4 M Series, 6.35mm (1/4in) stereo jack, vertical PCB mount, https://www.neutrik.com/en/product/nc5mav B Series, 3 pole female XLR receptacle, grounding: separate ground contact to mating connector shell and front panel, steel retention lug, horizontal PCB mount, asymmetric push, https://www.neutrik.com/en/product/nc3fbh2-da B Series, 5 pole female XLR receptacle, grounding: separate ground contact to mating connector shell and front panel. Current design uses six IDC 2×8 connectors with 4 unused pins if supplying power, but not necessary for old fogeys like.

New Pull Request

Labels Milestones