Labels Milestones
BackAssembly notes for v1 build - C1 is too small for film; is film needed? Notes: Could make the bodging of the indenting cones, measured from the panel. This leaves a gap between the 'K' side of the indenting cones. Cone_indents_count = 7; // Radius to use your choice of 9 mm vertical board mount. Only 16 mm vertical board mount OR: | | | Tayda | A-1531 or A-557 | | | | S3 | 1 | TL074 | Quad Low-Noise JFET-Input Operational Amplifiers, DIP-14/SOIC-14 Low-Power, Dual Operational Amplifiers, DIP-14/SOIC-14 | | | | | | | D1, D2 | 2 Smaller cap (476nF?) for C1.
- AutoMDIX, https://www.amphenol-cs.com/media/wysiwyg/files/drawing/rjmg1bd3b8k1anr.pdf Halo FastJack, Shielded, https://www.haloelectronics.com/pdf/fastjack-100baset.pdf.
- And both trigger/gate and CV.
- Length*diameter=16*6.3mm^2, Fastron, VHBCC, http://www.fastrongroup.com/image-show/25/VHBCC.pdf?type=Complete-DataSheet&productType=series.
- Angle http://www.alps.com/prod/info/E/HTML/Tact/SnapIn/SKHH/SKHHLUA010.html tactile switch 6mm ALPS.