Labels Milestones
BackRotary switch? Special: this needs measuring, and leaving space for everything, lining things up more Make slider and LED footprints match current OpenSCAD model Checkpoint after tweaking footprints some more, starting over at 14hp Added hard sync to schematic, laid out PCB with exploratory 8hp layout 2x Sockets, all three pins need wires: glide in (sleeve and normal both GND) 6x Sockets, 2pin: - all step switches (all go to same bus 2x Pushbutton switches, all 2pin: - Glide attenuator (B10k) (join two left pins from below Pots, 2-pin: - Glide, manual (A100k) (two left pins, from below Clock rate (B100k) (not sure yet which 2 pins LED diameter 4.0mm Plated Hole as test Point, diameter 3.0mm z-position of LED center 1.0mm 2 pins diameter 3.0mm 2 pins LED diameter.
- 2.4803055,8.7598422 V 8.9566927" d="m 2.5787305,8.8582674 h -0.19685" d="M.
- From trigger,\nnormalization is removed from.