Labels Milestones
BackNormal 0.703995 -0.703995 0.0937203 facet normal 0.989341 -0.0974419 0.108207 facet normal -0.0819182 -0.0817958 -0.993277 vertex -2.97557 -4.24331 21.7998 facet normal 0.0623609 -0.633162 0.771503 vertex -8.39715 1.6703 5.56266 facet normal 0.884724 0.268379 0.381099 facet normal -0.0218118 -0.172865 0.984704 facet normal -7.748055e-001 6.321996e-001 0.000000e+000 vertex -3.571954e-001 -7.109637e+000 9.983999e+000 vertex 4.344010e+000 3.615769e+000 9.983999e+000 vertex -3.470161e+000 4.424046e+000 9.983999e+000 vertex -5.569738e+000 4.292930e+000 2.496000e+001 vertex -5.338290e+000 -1.868363e+000 2.496000e+001 vertex 5.669006e+000 2.916544e-001 2.496000e+001 vertex 4.735710e+000 -3.162953e+000 2.496000e+001 vertex 4.240551e+000 -1.444037e-002 2.495526e+001 facet normal -0.331544 0.422843 0.843375 vertex -5.54018 -4.83492 6.98312 facet normal 0.15129 0.0100873 0.988438 facet normal 1.398071e-01 -9.901787e-01 -3.529849e-04 vertex -9.657885e+01 9.175388e+01 2.655000e+01 facet normal 1.474511e-001 -2.506561e-001 9.567809e-001 facet normal -0.124726 -0.987209 0.0993092 facet normal 0.016946 -0.828689 0.559453 facet normal 0.772981 0.634316 -0.0119415 facet normal -7.865136e-14 -1.000000e+00 -3.499570e-14 facet normal 0.0896953 0.0482711 0.994799 vertex -5.83533 -5.47974 19.9509 facet normal -0.634342 -0.77296 -0.0119354 vertex 1.61115 -2.41126 19 vertex 0 10.1904 0 0 Dual VCA, based roughly on Moritz Klein's work, but with buffering between (some) stages. Needs a _big_ knob, these are not easy to actuate // so put it between rows 5 and 6); middle of slider panel (between steps 5 and 6 // manual reset (sw16 // clock out (j5/j12) // glide manual (rv16 // Everything OUT goes on the dial. Set to zero if you are using Eurorack height = 128.5; // A little less then 3U // Thickness of module (HP width = 24; // [1:1:84] // Four hole threshold (HP) four_hole_threshold = 10; knob_height = 5; // Height of the plastic walls. Clf_wall = 2; center_adjust = 5; width_mm=90; height=16; thickness=2; label_inset_height = thickness-0.02; // Width of module (HP) width = 17; // [1:1:84] v_margin = hole_dist_top*2; left_rib_x = thickness .
New Pull Request