Labels Milestones
BackBarely, to poke through the board, adding an extra cross-board wire is needed, vs 3 if the PCB enough for nut, but could also be done with a capacitor / resistor pair, see Fireball's hard sync to schematic, laid out PCB with on-board components Added hard sync to schematic, laid out PCB with exploratory 8hp layout Schematics/Enlarge/Enlarge.kicad_prl | 10 uF | Unpolarized capacitor | | | | | | C1, C11 | 2 pin Molex connector 2.54 mm spacing D 3 pin Molex connector 2.54 mm spacing Pin header 2.54 mm spacing | Tayda | A-804 | | | J9 | 1 | AudioJack2_SwitchT | Audio Jack, 2 Poles (Mono / TS), Switched T Pole (Normalling)"/>