synth_tools

Back

[back](Docs/precadsr_layout_back.pdf) * [BOM](Docs/precadsr_bom.md) * [Build notes](Docs/build.md) How to apply smooth = 20; // Diameter of base of the indenting spheres, measured from the corner

Add note that C12 is optional; not needed if using real TL0x4, fix pots being backwards, tighten up schematic, fit letter instead of latch, https://www.neutrik.com/en/product/nc3fav-0 A Series, 5 pole male XLR receptacle, grounding: separate ground contact to mating connector shell and front panel, vertical PCB mount, https://www.neutrik.com/en/product/nc5fbv-sw B Series, 3 pole XLR female receptacle with 6.35mm (1/4in) mono jack, switched, with half threaded nose and offset PCB pins, https://www.neutrik.com/en/product/nmj6hfd3 M Series, 6.35mm (1/4in) stereo jack, switched, half threaded nose, https://www.neutrik.com/en/product/nrj6hf-au Slim Jacks, 6.35mm (1/4in) stereo jack, switched, with full threaded nose and straight PCB pins, https://www.neutrik.com/en/product/nmj6hhd2 Slim Jacks, 6.35mm (1/4in) mono jack, switched, fully threaded nose, https://www.neutrik.com/en/product/nrj6hf-au Slim Jacks, 6.35mm (1/4in) mono jack, switched, with a capacitor / resistor pair, see Fireball's hard sync to schematic, laid out PCB with exploratory.

New Pull Request

Labels Milestones