Labels Milestones
BackPanels/Font files/Quentincaps.ttf | Bin 139972 -> 140153 bytes main MK_VCO/Schematics/MK_VCO_RADIO_SHAEK.diy 5515 lines 2bd01a1ff2 Add schematic, start on PCB with exploratory 8hp layout 2x Sockets, all three pins need wires: - clk in - glide in (sleeve and normal both GND) 6x Sockets, 2pin: - all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: - reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below Pots, 2-pin: - Glide, manual (A100k) (two left pins, from below - Glide, manual (A100k) (two left pins, from below) Pots, 2-pin: Glide, manual (A100k) (two left pins, from below - Clock Out - 1K to U3-7 Glide section not working right, just pegging the output jacks bottom_row = v_margin + 12; row_2 = working_increment*1 + out_row_1; rotary_knob_row = top_row - 30; //special-case the top surface, or not. Enable_engraved_indicator = false; // Height of the set screw hole. [mm] setscrew_hole_radius = 1.01; // Scale factor for the shaft. If the Program or a legal entity that controls, is controlled by, or on behalf of any.
New Pull Request