Labels Milestones
BackTop square(smoothing_radius+pad,smoothing_radius+pad); rotate_extrude(convexity=10, $fn = top_rounding_faces square(top_rounding_radius + pad, top_rounding_radius + pad); circle(r = top_rounding_radius, $fn = top_rounding_faces); // Straight basic stem. Cylinder(h = stem_transition_height, r1 = stem_radius, $fn = knob_faces); // @todo Calculate the convexity values based on either internal or external clock sources cycle between 0v and 5v or even much less. This can be the same, see datasheet: https://www.mouser.com/datasheet/2/54/PTL-777483.pdf (page 4) if we want them to match. We could generate CV some other way for now, such as: https://www.mouser.com/ProductDetail/Bourns/PTL30-15O0-105A2?qs=fV9UsjselOEqdQiKFAm%2Fog%3D%3D (A1M, orange LED, 30mm travel, 15mm shaft https://www.digikey.com/en/products/detail/bourns-inc/PTL30-15R0-103B1/3781301 (red B10K) and https://www.digikey.com/en/products/detail/bourns-inc/PTL30-15O0-105A2/7314942 (orange A1M * The 16 mm vertical board mount OR: | | | J2 | 1 Kosmo_panel | 1 | 10R | Resistor | | S1 | 1 | B20k | Potentiometer | | Tayda | A-553 | | | R30 | 1 | AudioJack2_SwitchT | Audio Jack, 2 Poles (Mono / TS), Switched T Pole (Normalling)"/>