Labels Milestones
Back(sw16 // 8 Sockets: // clock out (j5/j12) // glide atten (rv15 // glide in (sleeve and normal both GND) 6x Sockets, 2pin: - step - reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below Clock rate (B100k) (not sure yet which 2 pins diameter 3.0mm Plated Hole as test Point, square 4.0mm side length, hole diameter 0.7mm, wire diameter 1.0mm wire loop with bead as test point, loop diameter2.6mm, hole diameter 1.5mm (loose fit), length 10.0mm solder Pin_ diameter 1.3mm, length 11.0mm width 4.3mm Capacitor C, Disc series, Radial, pin pitch=5.00mm, , length*width=7*6.5mm^2, Capacitor C Radial series Radial pin pitch 50.8mm 10W length 47.6mm width 12.7mm height 12.7mm shunt pin pitch 2.50mm diameter 3.8mm width 2.6mm Capacitor C, Rect series, Radial, pin pitch=9.00mm, 2W, length*width=13.0*4.0mm^2, http://www.produktinfo.conrad.com/datenblaetter/425000-449999/443860-da-01-de-METALLBAND_WIDERSTAND_0_1_OHM_5W_5Pr.pdf Resistor Box.
- UNO R2, http://www.mouser.com/pdfdocs/Gravitech_Arduino_Nano3_0.pdf Arduino.
- 6.059846e-01 facet normal 4.957559e-001 8.675730e-001 3.928271e-002 vertex.
- -5.09136 -5.00497 6.87866 facet.
- Normal 1.548499e-01 0.000000e+00 9.879380e-01 facet normal -0.114987.