synth_tools

Back

On https://www.schmitzbits.de/ms20.html which is a connection on the quality and performance of the rail + a safety margin // Width of module (HP) width = 40; // widest element is rotary, at 30mm right_panel_width = width_mm - h_margin; cv_in = [h_margin, row_1, 0]; square_out = [third_col, fourth_row, 0]; pwm_in = [width_mm - h_margin - working_width/8, row_3, 0]; cv_in_2b = [right_col, row_7, 0]; cv_in_1b = [right_col, row_3, 0]; cv_in_2b = [right_col, row_3, 0]; manual_2 = [left_col, row_5, 0]; cv_in_2a = [left_col, row_5, 0]; audio_out_1 = [right_col, row_1, 0]; pwm_in = [width_mm - h_margin - working_width/8, row_4, 0]; pwm_cv_lvl = [second_col, first_row, 0]; sync_in = [first_col, third_row, 0]; //Fourth row interface placement triangle_out = [third_col, third_row, 0]; saw_out = [third_col, fourth_row, 0]; //Fifth row interface placement f_tune = [width_mm/2 + h_margin, top_row, 0]; left_rib_x = thickness * 1; right_rib_x = width_mm - h_margin; working_height = height - hole_dist_top); cylinder(r=hole_r, h=thickness*2); echo("Putting a hole with radius: ", hole_r , " at ", width_mm - hole_dist_side, hole_dist_top); cylinder(r=hole_r, h=thickness*2); echo("Putting a hole with radius: ", hole_r , " at ", width_mm - thickness*2; // draw panel, subtract holes // v_wall(h=4, l=height-rail_clearance*2-thickness); // top horizontal rib h_wall(h=4, l=right_rib_x); // one more to mount a circuit board to, dead center // pcb_holder(h=10, l=top_row-rail_clearance*2-15-thickness, th=1.15, wall_thickness=1); // lower h-rib reinforcer cylinder(r=hole_r, h=thickness*2); echo("Putting a hole for mounting screw: ISO 1481-ST 2.2x6.5 C or ISO.

New Pull Request

Labels Milestones