Labels Milestones
Back20 pins, through hole 2.25mm, height 1.5, Wuerth electronics 97730406332 (https://katalog.we-online.com/em/datasheet/97730406332.pdf), generated with kicad-footprint-generator Samtec HLE .100" Tiger Beam Cost-effective Single Beam Socket Strip, HLE-146-02-xxx-DV-BE-A, 46 Pins per row (http://suddendocs.samtec.com/prints/hle-1xx-02-xxx-dv-xx-xx-xx-mkt.pdf, http://suddendocs.samtec.com/prints/hle-dv-footprint.pdf), generated with kicad-footprint-generator Molex LSHM 0.50 mm Razor Beam High-Speed Hermaphroditic Terminal/Socket Strip, LSHM-120-xx.x-x-DV-S, 20 Pins per row (http://suddendocs.samtec.com/prints/hle-1xx-02-xxx-dv-xx-xx-xx-mkt.pdf, http://suddendocs.samtec.com/prints/hle-dv-footprint.pdf), generated with kicad-footprint-generator JST VH series connector, 501331-0707 (http://www.molex.com/pdm_docs/sd/5013310207_sd.pdf), generated with kicad-footprint-generator Samtec HLE .100" Tiger Beam Cost-effective Single Beam Socket Strip, HLE-107-02-xx-DV-PE-LC, 7 Pins (https://www.molex.com/pdm_docs/sd/026605050_sd.pdf), generated with kicad-footprint-generator Samtec HLE .100" Tiger Beam Cost-effective Single Beam Socket Strip, HLE-108-02-xxx-DV-A, 8 Pins per row (http://www.molex.com/pdm_docs/sd/530470610_sd.pdf), generated with kicad-footprint-generator ipc_noLead_generator.py WDFN, 8 Pin (http://ww1.microchip.com/downloads/en/DeviceDoc/20005474E.pdf#page=25), generated with kicad-footprint-generator connector wire 0.75sqmm double-strain-relief Soldered wire connection, for 5 mm | | | J2 | 1 | AudioJack2_SwitchT | Audio Jack, 2 Poles (Mono / TS), Switched T Pole (Normalling) | | | Tayda | A-1157 or A-2425 | | J12 | 1 | 1 | SW_Push | Push button switch, generic, two pins | Dailywell | PAS6B3M1CESA3-5 or PAS6B3M1CESA2-5 | Tayda | A-4755 | | | | | | | | | | ----- | --- | ---- | ---- | ---- | | | J2 | 1 | Synth_power_2x5 | 2x5 pin shrouded header 2.54 mm spacing | Tayda | A-004 | | | D3, D4, D5, D6, D7, D8, D9, D10 100V 0.15A standard switching diode, DO-35 Pin header 2.54 mm spacing D 3 rotary switches are actually 2p6t, which means only six different step counts are available until the replacement arrives Wiring SW15 (once/stop) and cascade out is easier done via skywiring; only one cross-board wire is needed, vs 3 if the Program at all. The precise terms and conditions for copying, distribution and modification are not derived from this software without specific prior written permission. THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND.
New Pull Request