Labels Milestones
BackMount, https://www.neutrik.com/en/product/nc3mav B Series, 5 pole female XLR receptacle, grounding: ground contact to mating connector shell and front panel, horizontal PCB mount, https://www.neutrik.com/en/product/nc3fah1 A Series, 5 pole male XLR receptacle, grounding: separate ground contact to mating connector shell and front panel, vertical PCB mount, black chrome shell, https://www.neutrik.com/en/product/nc5fbv-b B Series, 3 pole female XLR receptacle, grounding: mating connector shell and front panel, horizontal PCB mount, retention spring instead of the indenting cones. [mm] // -------------------------------------- // Whether to create cutouts around the far leg of the object. HoleDepth = 10; label_font = 6; //knob_radius top_row = height - v_margin - title_font_size*2; saw_out = [h_margin + working_width/4, row_1, 0]; fm_pot = [input_column - h_margin/2, row_1, 0]; saw_out = [h_margin + working_width/4, row_1, 0]; triangle_out = [output_column, row_2, 0]; fm_lvl = [h_margin+working_width/8, row_2, 0]; fm_lvl = [h_margin+working_width/8, row_2, 0]; pwm_in = [width_mm - h_margin - working_width/8, row_3, 0]; cv_in_2b = [right_col, row_6, 0]; cv_1b_atten = [right_col, row_7, 0]; manual_1 = [left_col, row_7, 0]; manual_1 = [left_col, row_5, 0]; audio_out_1 = [right_col, row_5, 0]; cv_in_2a = [left_col, row_7, 0]; manual_1 = [left_col, row_3, 0]; c_tune = [second_col, fourth_row, 0]; triangle_out = [width_mm-h_margin-working_width/4, row_1, 0]; f_tune = [h_margin+working_width/8, row_4, 0]; pwm_cv_lvl = [second_col, third_row, 0]; fm_lvl = [second_col, first_row, 0]; //Second row interface placement sync_in = [first_col, third_row, 0]; //Fourth row interface placement fm_in = [h_margin+working_width/8, row_2, 0]; fm_in = [first_col, third_row, 0]; fm_lvl = [second_col, fourth_row, 0]; //Fifth row interface placement fm_in = [first_col, fifth_row, 0]; pwm_duty = [width_mm - h_margin - working_width/8, row_3, 0]; c_tune = [width_mm/2, top_row, 0]; f_tune = [h_margin+working_width/8, row_4, 0]; left_rib_x = hole_dist_side + thickness; right_rib_x = width_mm - h_margin; input_column = h_margin; col_middle = col_left + (15.6 + 1.5 + 7 + 8); // pot + led + switch? Col_right = width_mm - thickness*2; // draw panel, subtract holes panel(width); // waves out wall(h=4, w=width_mm-hole_dist_top-4); // one more vertical to mount the circuit board to module.
New Pull Request