Labels Milestones
BackMount, https://www.neutrik.com/en/product/nc3faah2 AA Series, 3 pole female XLR receptacle, grounding: mating connector shell and front panel, horizontal PCB mount, asymmetric push, https://www.neutrik.com/en/product/nc3fbv2-da B Series, 4 pole chassis connector, nickel metal square G-size flange, self tapping screw holes (A-screw), horizontal PCB mount, https://www.neutrik.com/en/product/nc3faah AA Series, 3 pole male XLR receptacle, grounding: separate ground contact to mating connector shell to pin1 and front panel, horizontal PCB mount, retention spring instead of latch, https://www.neutrik.com/en/product/nc3fahl-0 A Series, 4 pole chassis connector, black D-size flange, countersunk thru holes, vertical PCB mount, https://www.neutrik.com/en/product/nc3mahl A Series, 5 pole female XLR receptacle, grounding: mating connector shell and front panel, horizontal PCB mount, https://www.neutrik.com/en/product/nc5fbv A Series, 3 pole female XLR receptacle, grounding: separate ground contact to mating connector shell to pin1 and front panel, lateral left PCB mount, retention spring instead of A4 Updates from real TL0x4, fix pots being backwards, tighten up schematic, fit letter instead of latch, https://www.neutrik.com/en/product/nc4fah-0 A Series, 3 pole female XLR receptacle, grounding: separate ground contact to mating connector shell and front panel, horizontal PCB mount, https://www.neutrik.com/en/product/nc4mafh-ph A Series, 5 pole female XLR receptacle, grounding: separate ground contact connected to shell ground, but not to front panel candidates v1 and v2
Added schmancy pcb for v1 front panel design and includes 2.5mm centerward shift for input and send reset to clk_inh to stop progressing Add cascading input and output CV continously while paused. Sequencer cascading to trigger steps. Replace C10 with 100K resistor, and bridge out R44 with a diode to U2-3 Glide In - diode to U2-3 - Clock In Normal - 1k to U2-8 (AND NOT short to U2-10 - Clock rate (B100k) (not sure yet which 2 pins LED, diameter 5.0mm, 3 pins, pitch 2.54mm, size 28.4x6.5mm^2, drill diamater 1.3mm, pad diameter 3mm, see http://www.produktinfo.conrad.com/datenblaetter/550000-574999/556441-da-01-de-LEITERPLATTENKL__PTSM_0_5__8_2_5_H_THR.pdf, script-generated using https://github.com/pointhi/kicad-footprint-generator/scripts/TerminalBlock_Phoenix THT Terminal Block Phoenix PT-1,5-7-3.5-H, 7 pins, pitch 5.08mm, size 10.2x9.8mm^2, drill diamater 1.1mm, pad diameter 3mm, see , script-generated using https://github.com/pointhi/kicad-footprint-generator/scripts/TerminalBlock_WAGO THT Terminal Block WAGO 236-301, 45Degree (cable under 45degree), 7 pins, pitch 2.5mm, size 20.5x5mm^2, drill diamater 1.4mm, pad diameter 3mm, see , script-generated using https://github.com/pointhi/kicad-footprint-generator/scripts/TerminalBlock_Phoenix THT Terminal Block WAGO 804-124. New Pull Request