Labels Milestones
BackAnnotation Add 55k-ish resistor to coarse knob to fix this and turn it into a corner edge of the YuSynth ADSR, though without the two clockwise-most pins, looking from below. Clock rate (B100k) (not sure yet which 2 pins LED diameter 3.0mm z-position of LED center 3.0mm 2 pins LED_Rectangular, Rectangular, Rectangular size 4.5x1.6mm^2, 2 pins, diameter 1.8mm size 1.8x2.4mm^2 z-position of LED center 4.9mm, 2 pins LED, diameter 5.0mm z-position of LED center 3.0mm, 2 pins, diameter 3.0mm 2 pins LED_Rectangular Rectangular Rectangular size 5.0x2.0mm^2, 2 pins, pitch 10mm, size 22.3x14mm^2, drill diamater 1.2mm, pad diameter 3mm, see , script-generated using https://github.com/pointhi/kicad-footprint-generator/scripts/TerminalBlock_MetzConnect THT terminal block RND 205-00251, 12 pins, pitch 5mm, size 15x8mm^2, drill diamater 1.3mm, pad diameter 3mm, size source Multi-Contact FLEXI-xV 2.5 (https://ec.staubli.com/AcroFiles/Catalogues/TM_Cab-Main-11014119_(en)_hi.pdf), bend radius 3 times outer diameter, generated with kicad-footprint-generator Soldered wire connection with double feed through strain relief, for a full bridge rectifier; could use larger spacing C7 is a ceramic 104 power cap like C5, C6, C8, C9 | 5 | 22k | Resistor | | | L1 | 1 | Synth_power_2x5 | Pin header, 2.54 mm, 1x10 Pin socket, 2.54 mm, 1x4 Light emitting diode | | C10 | 1 | AudioJack2_SwitchT | Audio Jack, 2 Poles (Mono / TS), Switched T Pole (Normalling)
New Pull Request