Labels Milestones
Back* TBD, needs testing * State Gates (from Befaco) TBD, needs testing * State Gates (from Befaco) * TBD, needs testing; but if LEDs are possible, this should be possible, too * Manual trigger * See manual step (sw13) - pushbutton // glide in (sleeve and normal both GND 6x Sockets, 2pin: - step - reset in - glide in (sleeve and normal both GND 6x Sockets, 2pin: - all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: reset Pots, 3-pin: Glide attenuator (B10k) (join two left pins from below - Clock POT is too small for film; is film needed? - Fix R25/R1 connection - One idea: add a voltage to trigger steps. Replace C10.
- 100644 Hardware/PCB/precadsr/ao_tht.pretty/SolderWirePad_1x01_Drill1mm.kicad_mod create mode 100644 Hardware/PCB/precadsr/ao_tht.pretty/SOT-23_Handsoldering.kicad_mod create mode.
- Vertex -8.35846 -7.75552 0.18985.
- 112.1 (end 162.78 113.28 (end 167.5 95.706712.
- 205-00020, 10 pins, dual.