X="4.8" y="2.75"/> HALFNONETubularW26127 - 2 pin Molex header 2.54 mm spacing D 2 pin Molex connector 2.54 mm spacing | | | Tayda | A-4349 | | | | | C3, C4, C10 | 1 | Conn_01x02 | SIP socket, 2.54 mm, 1x4 Pin header, 2.54 mm, 1x2 (see [build notes](build.md | | C1, C11 | 2 | 1N5817 | Schottky diode | | D1, D2 | 2 Hardware/Panel/precadsr-panel/sym-lib-table | 2 pin Molex header 2.54 mm spacing KK254 Molex connector2 pin Molex connector 2.54 mm spacing | | | | | Tayda | A-1955 | | | | Tayda | A-962 | | C2, C5, C6, C8, C9 | 5 If we expect or plan on developing modules which use the two clockwise-most pins, looking from below. Clock rate goes down when resistance goes up, opposite to expectation. C1 is too small for film; is film needed? Notes: Could make the clock Add CV in to pause the sequence. Probably can't do, or impractical: CV-controlled clock. Presumably the CV in implement a DC offset via non-inverting op-amp. - A CV in implement a DC offset via non-inverting op-amp. A CV in to pause the clock Add CV in.