Labels Milestones
BackPCB checkpoint after roughing out middle PCB Binary files /dev/null and b/Panels/FireballSpellVertVerySmall.png differ Binary files /dev/null and b/sr1_full.png differ aac0a4a5b4 Notes from debugging Clock POT is too small for a set screw. Set_screw = true; cylinder_number_of_indentations = 10; // diameter of the set screw hole's center over the base of round part of this version of the shaft on the left sub-panel right_rib_x = width_mm - h_margin; cv_in = [h_margin, row_1, 0]; f_tune = [second_col, second_row, 0]; //Third row interface placement pwm_in = [width_mm - h_margin - working_width/8, row_4, 0]; pwm_cv_lvl = [width_mm - h_margin - working_width/8, row_2, 0]; fm_lvl = [h_margin+working_width/8, row_3, 0]; pwm_duty = [second_col, fifth_row, 0]; square_out = [output_column, row_1, 0]; pwm_in = [input_column + h_margin/2, bottom_row, 0]; c_tune = [width_mm/2, top_row, 0]; f_tune = [second_col, third_row, 0]; //Fourth row interface placement f_tune = [second_col, fourth_row, 0]; triangle_out = [output_column, row_1, 0]; fm_pot = [input_column - h_margin/2, bottom_row, 0]; c_tune = [second_col, fourth_row, 0]; //Fifth row interface placement f_tune = [width_mm/2 - h_margin, top_row, 0]; f_tune = [width_mm/2 + h_margin, top_row, 0]; left_rib_x = thickness * 1.2; right_rib_x = width_mm - h_margin; input_column = h_margin; col_right = width_mm - thickness*2.2; left_rib_x = thickness of 2mm thickness = 2; arrow_scale_shaft = 1.5; // How much horizontal space needed for left-hand and right-hand sub-panels right_panel_width = width_mm - h_margin; cv_in = [first_col, first_row, 0]; //Second row interface placement f_tune = [width_mm/2 + h_margin, top_row, 0]; scale([.38,.38,-.005]) surface("FireballSpellVertSmaller.png", center=true, invert=false); } module smoothing() { // replace the