Labels Milestones
BackFirst_row = 25.65; //mm second_row = 47.25; //mm third_row = 65.75; //mm fourth_row = 88.25; //mm fifth_row = 108.75; //mm // Center two holes two_holes_type = "opposite"; // [center, opposite, mirror] // Hole radius (mm) hole_r = 1.7; // Hole radius (mm) hole_r = 1.7; // Hole distance from the front panel. Tightening it down here: https://www.youtube.com/watch?v=mmd_7p62Z18 Samba Reggae 1 is probably good // = length of the version of the usual pattern MS1: * <- Play * every other measure CAX: -- can also just play SR2 SR 1.pdf Normal file Unescape panelThickness = 2; center_adjust = 5; //knob_radius top_row = height - v_margin*2 - title_font_size; Experimenting with more panel layout ideas left_rib_x = hole_dist_side + thickness; right_rib_x = width_mm - h_margin; working_height = height - v_margin - title_font; saw_out = [third_col, third_row, 0]; fm_in = [input_column + h_margin/2, row_1, 0]; fm_pot = [input_column - h_margin/2, row_1, 0]; fm_in = [input_column + h_margin/2, bottom_row, 0]; fm_in = [h_margin+working_width/8, row_2, 0]; f_tune = [second_col, fifth_row, 0]; pwm_duty = [second_col, first_row, 0]; c_tune = [width_mm/2 + h_margin, top_row, 0]; f_tune = [width_mm/2 + h_margin, top_row, 0]; f_tune = [width_mm/2 - h_margin, top_row, 0]; f_tune = [width_mm/2 + h_margin, top_row, 0]; left_rib_x = hole_dist_side + thickness; width_mm = hp_mm(width); // where to put the output jacks input_column = h_margin; bottom_row = v_margin + 12; //knob_radius top_row = height - 25; // build up seven rows; middle.
New Pull Request