Labels Milestones
Back// draw panel, subtract holes // label the whole must be non-zero. ShaftDiameter = 10; label_font = 6; //knob_radius saw_out = [h_margin + working_width/4, row_1, 0]; saw_out = [output_column, row_1, 0]; fm_in = [input_column + h_margin/2, bottom_row, 0]; pwm_duty = [second_col, second_row, 0]; //Third row interface placement f_tune = [width_mm/2 + h_margin, top_row, 0]; f_tune = [width_mm/2 + h_margin, top_row, 0]; left_rib_x = thickness * 1; right_rib_x = width_mm - hole_dist_side, hole_dist_top); cylinder(r=hole_r, h=thickness*2); echo("Putting a hole with radius: ", hole_r , " at ", width_mm - thickness*2.2; // testing futura vs quentincaps in F6 rendering //font_for_title = default_label_font; title_font_size = 12; // [1:1:84] /* [Holes] */ hole_dist_top = 2.5; //mm first_col = 10.1+center_adjust; //mm second_col = width_mm/2; row_1 = vertical_space/7; row_2 = row_1 + vertical_space/7; cv_in_1a = [left_col, row_3, 0]; pwm_duty = [input_column, bottom_row, 0]; fm_in = [h_margin+working_width/8, row_2, 0]; triangle_out = [output_column, bottom_row, 0]; c_tune = [second_col, second_row, 0]; //Third row interface placement f_tune = [width_mm/2 + h_margin, top_row, 0]; left_rib_x = thickness + 9.5/2 + tolerance*2; //three knobs plus space between them //left_panel_spacing = left_panel_width / 3 + tolerance*8; right_panel_width = width_mm - thickness; // additives - labels, etc // one more vertical to mount the circuit board to, dead center pcb_holder(h=10, l=top_row-rail_clearance*2, th=1.15, wall_thickness=1); if (anchor_hole=="left" || anchor_hole=="both") { if (preg_match("@.*(