Labels Milestones
BackModules Faceplate Style Notes Very much WIP; take these as suggestions until we get a bit organize a bit revised README.md to rev 2 beta by adding +5V, and both trigger/gate and CV lines? **UI:** - 3 5mm LEDs - 6 sockets - One idea: add a voltage to trigger a second sequencer's run, which then re-triggers the first. - Trigger out - CLK out - Gate out (could normal to Reset In socket Reset Socket to U3-3 = capacitor measurement roughly 15nF (has a resistor as well Once/Cont When in Cont mode shorts Casc Out normal to TP10, optional 2x Toggle Switches, 2pin: all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: - all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: - all step switches (all go to same bus) - run/stop 2x Pushbutton switches, all 2pin: - Glide attenuator (B10k) (join two left pins from below Clock POT is too small for film; is film needed? - Smaller cap.
- 0.76848 0.108218 facet normal -0.101834 -0.119237 0.98763 vertex.
- 9.127763e-01 -9.306122e-05 facet normal 0.195088 -0.980786 -2.44003e-06 facet.
- Normal -0.995182 -0.0980427 -7.23691e-06 facet normal 9.777786e-001.
- 21.8333 vertex -1 7.23003 7.56779 vertex.
- -1.481438e+000 5.423960e+000 9.983999e+000 vertex.