Y="2.9"/> <-- CV In main MK_VCO/Panels/fireball_vco_14hp_v1.scad 330 lines width = 38; // [1:1:84] square_out = [third_col, fourth_row, 0]; triangle_out = [third_col, fourth_row, 0]; pwm_in = [input_column - h_margin/2, row_1, 0]; pwm_in = [width_mm - h_margin - working_width/8, row_4, 0]; pwm_cv_lvl = [width_mm - h_margin - working_width/8, row_2, 0]; cv_2b_atten = [right_col, row_5, 0]; audio_out_1 = [right_col, row_6, 0]; cv_1b_atten = [right_col, row_6, 0]; cv_1b_atten = [right_col, row_6, 0]; cv_1b_atten = [right_col, row_1, 0]; pwm_in = [first_col, fourth_row, 0]; triangle_out = [third_col, fourth_row, 0]; //Fifth row interface placement fm_in = [h_margin+working_width/8, row_2, 0]; f_tune = [width_mm/2 - h_margin, top_row, 0]; left_rib_x = hole_dist_side + thickness; right_rib_x = width_mm - thickness*2.2; left_rib_x = 0; right_rib_x = width_mm - hole_dist_side, hole_dist_top); cylinder(r=hole_r, h=thickness*2); echo("Putting a hole with radius: ", hole_r , " at ", width_mm - col_right + tolerance*4; // column from edge plus hole radius h_wall(h=4, l=slider_spacing * 10 + center_adjust; right_col = width_mm - col_right + tolerance*4; //three knobs plus space between two resistors, and updated with more panel layout Based on.
alt
click/enter