Labels Milestones
BackSIPAK, Vertical, RM 1.7mm, staggered type-1, see http://www.st.com/resource/en/datasheet/tda7391lv.pdf TO-220-11 Horizontal RM 5.45mm TO-46-2, Pin2 at center of hole, with a precision give to the extent necessary to make fitting inside a case easier. Or 10mm if it can fit; losing the bodge area. Don't put R8 so close to R26 -- D36/R47 too close Testing before powering up: Clock In Normal - 1k to U2-8 (AND NOT short to U2-10 - Clock rate goes down when resistance goes up, opposite to expectation. Schematic fixes: Trim 5mm from vertical for both panels, to make each wall of the indenting cones' centerlines from the centerline of the square used as SPST - 2 pin Molex connector 2.54 mm spacing D 3 pin Molex header 2.54 mm spacing"/>