Labels Milestones
BackImages/retrigger.png Normal file Unescape Hardware/Panel/precadsr_panel_al_Gerbers/precadsr_panel_al-F_Paste.gbr Normal file Unescape Hardware/PCB/precadsr/ao_tht.pretty/C_Rect_L7.2mm_W2.5mm_P5.00mm_FKS2_FKP2_MKS2_MKP2.kicad_mod Normal file Unescape left_rib_x = thickness + 6 + tolerance; // left_rib_x = thickness + 9.5/2 + tolerance*2; // rib + half a jack col_right = width_mm - 10 LEDs 3 sockets 6 sockets Potentiometers: One potentiometer for internal clock rate. One SPDT switch to adjust CV output range, switch between 5v and 2.5v max (or whatever is configured). Momentary-normal-off pushbutton to manually reset. LEDs: One per step, to set output voltages. (10) - One SPDT switch per step, to set clock rate (if onboard clock is used) (rv11 // 1 for cv glide atten (rv15 // glide in (sleeve and normal both GND 6x Sockets, 2pin: - all step switches (all go to same bus run/stop 2x Pushbutton switches, all 2pin: - reset Pots, 3-pin: - Glide attenuator (B10k) (join two left pins from below Pots, 2-pin: - Glide, manual (A100k) (two left pins, from below) - Clock in socket with amplifier to handle weaker (<6v) signals Sequencer cascading to trigger a second.
New Pull Request