Labels Milestones
BackUse for the articles that helped implement this. Ct = -0.1; // circle translate? Not sure. Circle_radius = knob_radius_top; // just match the top edge. [mm] top_rounding_radius = 8; // Cylinder faces to use the two clockwise-most pins, looking from below. Clock rate goes down when resistance goes up, opposite to expectation. C1 is too small; need more than 100k to get 1:1 between schematic and PCB, no warnings d62e7c6861 More work finding space for everything, lining things up more Make slider and LED footprints match current OpenSCAD model .gitignore | 1 | SW_3PDT_x3 | Switch, single pole double throw, illuminated paddle, red and green LEDs K switch normally-open pushbutton push-button Lamp D Push button switch, generic, two pins | | R8, R10, R12 | 3 | 2N3904 | 0.2A Ic, 40V Vce, Small Signal NPN Transistor, TO-92"/>