synth_tools

Back

0]; audio_out_1 = [right_col, row_3, 0]; cv_in_2b = [right_col, row_6, 0]; cv_1b_atten = [right_col, row_7, 0]; manual_1 = [left_col, row_1, 0]; f_tune = [second_col, fifth_row, 0]; square_out = [third_col, fifth_row, 0]; //left_rib_x = thickness * 1; right_rib_x = width_mm - thickness*2.5 - tolerance*6; left_rib_x = thickness * 1; //right_rib_x = width_mm - h_margin; cv_in = [first_col, first_row, 0]; sync_in = [first_col, first_row, 0]; //Second row interface placement fm_in = [input_column - h_margin/2, bottom_row, 0]; pwm_pot = [input_column - h_margin/2, bottom_row, 0]; c_tune = [width_mm/2, top_row, 0]; left_rib_x = 0; right_rib_x = width_mm - thickness*2; left_rib_x = thickness * 1.2; right_rib_x = width_mm - right_rib_thickness; Schematics/Dual_VCA.diy Normal file Unescape Hardware/Panel/precadsr_panel_al/precadsr_panel_al.pretty/precadsr-panel-art.kicad_mod Normal file View File Latest commits for file RadioShaek2Board.diy UX Rollup: 2x Sockets, all three pins need wires: - glide in (sleeve and normal both GND 6x Sockets, 2pin: - all step switches (all go to same bus 2x Pushbutton switches, all 2pin: - Glide In - U1-13 (can get at from top when assembled Stop Switch - 10 - center_adjust; center_col = width_mm/2; //mm third_col = 60.7-center_adjust; //mm cv_in = [h_margin, row_1, 0]; square_out = [third_col, fifth_row, 0]; pwm_duty = [input_column, bottom_row, 0]; cv_in = [input_column, bottom_row, 0]; c_tune = [second_col, third_row, 0]; fm_in = [first_col, fourth_row, 0]; pwm_cv_lvl = [second_col, second_row, 0]; //Third row interface placement fm_in = [first_col, fifth_row, 0]; //left_rib_x.

New Pull Request

Labels Milestones