Type="power_in"/> Audio Jack, 2 Poles (Mono / TS)"/> Switch, triple pole double throw, separate symbols2x5 pin shrouded header 2.54 mm spacing 3 pin Molex header 2.54 mm spacing 2 pin Molex connector 2.54 mm spacing | Tayda | A-559 | | | Screws and spacers (see [build notes](build.md | | Tayda | A-1955 | | R31 | 1 | Conn_01x07 | \*(optional) SIP socket, 2.54 mm, 1x10 Pin header, 2.54 mm, 1x2 (see [build notes](build.md | | D1, D2, D3, D4, D5, D8, D9, D10 Standard switching diode, DO-35 | | D6, D7 | 2 | 10k | Resistor | | | Taydaa | A-4755 | | | Tayda | A-1605 | \* Fit SIP socket for\nsocketing capacitors C13 marked 1 nF\non first run PCBs as 1 nF. It should be possible, too * Manual trigger See manual step (sw13) // 1 to something more decisive, like 3x. Then a signal as low as 2v could works as an edge cut? Corrected in Rev 2.0 alpha 1: Properly assign potentiometer pads and trace routing to de-bodge the pots. Updates the potentiometer pads and thermal vias; see section 7.1 of http://www.st.com/resource/en/datasheet/DM00213872.pdf WLCSP-64, 8x8.