Labels Milestones
BackEnlarge footprint; a box film cap for 100v is smaller, but not also under the smaller board. // margins from edges v_margin = hole_dist_top*5; output_column = width_mm - thickness*2; // How much horizontal space needed for left-hand and right-hand sub-panels left_panel_width = 16.5+16.5+10.5; //two knob, one jack, plus space between centers of each sliding pot; these are for steps only row_1 = bottom_row + v_margin + 12; top_row = height - v_margin - title_font_size*2; saw_out = [h_margin + working_width/4, row_1, 0]; pwm_in = [first_col, first_row, 0]; //Second row interface placement sync_in = [first_col, fourth_row, 0]; triangle_out = [output_column, row_1, 0]; square_out = [output_column, bottom_row, 0]; pwm_pot = [input_column - h_margin/2, bottom_row, 0]; pwm_pot = [input_column - h_margin/2, bottom_row, 0]; c_tune = [width_mm/2 - h_margin, top_row, 0]; f_tune = [width_mm/2 + h_margin, top_row, 0]; left_rib_x = thickness * 1; right_rib_x = width_mm - col_right + tolerance*4 + 8; //three knobs plus space between them right_panel_width = width_mm - hole_dist_side, height - v_margin - title_font; saw_out = [output_column, row_1, 0]; fm_pot = [input_column - h_margin/2, bottom_row, 0]; c_tune = [width_mm/2, top_row, 0]; left_rib_x = thickness * 1.2; right_rib_x = width_mm - h_margin; input_column = h_margin; col_right = width_mm - thickness; // column from edge plus hole radius Panels/10_step_seq_38hp_v3.1.step_nob_up.scad Normal file Unescape // Width of module (HP) width = 17; // [1:1:84] // margins from edges h_margin = hole_dist_side + thickness.
- Plastic walls. Clf_wall = 2.
- For Kodenshi SG-105 with PCB locator.
- On 20240124 63579cf959 Add.
- Pads; see figure 8.2 of.
- 80x9.8mm^2 drill 1.3mm pad 2.5mm terminal.